J.I. Case 600
| 1957 |
600 Series | Standard-tread tractor |
|
Series map:
600
77.8hp*
*Estimated engine power for comparison only.
Production |
Manufacturer | J.I. Case
|
Standard-tread tractor |
Built in Racine, Wisconsin, USA |
Total built | 1,515
|
J.I. Case 600 Power |
Belt (claimed) | 70 hp 52.2 kW
|
Mechanical |
Two-wheel drive |
Steering | power assist
|
Disc brakes |
Open operator station. |
Capacity |
Fuel | 30 gal 113.6 L
|
Hydraulic system | 3.5 gal 13.2 L
|
Hydraulics |
Type | open center OptOptional
|
Capacity | 3.5 gal 13.2 L
|
Pressure | 1000 psi 69.0 bar
|
Pump flow | 15 gpm 56.8 lpm
|
Power Take-off (PTO) |
Rear PTO | independent OptOptional
|
Clutch | mechanical wet disc
|
Rear PTO Type | 540 (1.375)
|
Engine RPM | 540@1475
|
Belt Pulley |
Diameter | 13.5 inches 34 cm
|
Width | 8.25 inches 20 cm
|
RPM | 944
|
Speed | 3338 ft/min 1017.42 meters/min
|
Electrical |
Ground | negative
|
Charging system | generator
|
Charging amps | 12
|
Batteries | 2
|
Battery volts | 6
|
References |
 |
600 Tractors - Diesel and LP-Gas published in 1956, by J.I. Case |
Operator's Instruction Manual 600 Series Diesel Tractors (6425) published in 1956 |
Page information |
 |
Copyright 2024 TractorData.com® |
TractorData is a family-owned small business located in Minnesota that has been providing reference information on tractors since 1999. |
Peter Easterlund - owner/author |
Email: Peter@TractorData.com |
Updated on August 1, 2024 |
©2000-2024 - TractorData.com®. Notice: Every attempt is made to ensure the data listed
is accurate. However, differences between sources, incomplete listings,
errors, and data entry mistakes do occur.
Consult official
literature from the manufacturer before attempting any service or repair.