J.I. Case W-930
| 1960 - 1963 |
Industrial tractor |
|
Production |
Manufacturer | J.I. Case
|
Type | Industrial tractor
|
Factory | Racine, Wisconsin, USA
|
Mechanical |
Chassis | 4x2 2WD
|
Final drives | roller chain
|
Steering | power
|
Cab | Open operator station.
|
Photos |
No photos of the J.I. Case W-930 are currently available. To submit yours, email it to Peter@TractorData.com. Photos may only be used with the permission of the original photographer. |
Hydraulics |
Type | open center
|
Pressure | 1000 psi 69.0 bar
|
Pump flow | 17 gpm 64.3 lpm
|
Power Take-off (PTO) |
Rear PTO | independent
|
Clutch | wet disc
|
Rear RPM | 540 (1.375)
|
Engine RPM | 540@1450
|
W-930 Serial Numbers |
Location: | Serial number plate on the right of the W-930, on the side of the instrument panel.
|
Belt Pulley |
Diameter | 11.75 inches 29 cm
|
Width | 8.25 inches 20 cm
|
RPM | 1007
|
Speed | 3100 ft/min 944.88 meters/min
|
Electrical |
Ground | negative
|
Charging system | generator
|
Batteries | 2
|
Battery volts | 6
|
Battery AH | 200
|
References |
|
Industrial Tractors and Equipment published in 1960, by J.I. Case |
Operator's Instruction Manual W930 (9-971) published in 1960, by J.I. Case |
Page information |
Contact: Peter Easterlund |
Updated on March 31, 2021 |
Copyright 2021 TractorData LLC |
©2000-2021 - TractorData.com®. Notice: Every attempt is made to ensure the data listed
is accurate. However, differences between sources, incomplete listings,
errors, and data entry mistakes do occur.
Consult official
literature from the manufacturer before attempting any service or repair.